妻系列无码人妻免费视频_奇奇午夜理伦三级_一级无码黄色大片_欧美日韩国产中文视频_亚洲性网在线观看_超碰在线97中文_日本熟妇熟色97一本在线观看_给大家科普一下男生女生差差2023_日本欧美91精品成人久久久_熟女中文字幕乱码视频

Welcome to Chongqing Paco Sci. & Tech. Development Co., Ltd.
TEL: 86-23-68795340
11165 series gear pumps
Drive shaft sealing: Done with teflon packing (see doc. N° 643101).
Rotation speed: Up to 200 RPM, depending ont the product involved.
Standard rotation: Clockwise (A)
Temperature: Max. 135°C
Acceptable output pressure
For the 0.1cc/rev to 3.0cc/rev outputs, max. 100 bars
For the 6.0cc/rev output, max. 30 bars
Input/Output:G1/4"female, on the side
Drive shaft diameter: ? 12mm with 4mm key
Drive shaft to base height: 57.25mm standard ; height cannot be altered

Available outputs
0.1cc/rev、0.3cc/rev、0.6cc/rev、1.2cc/rev、1.8cc/rev 、2.4cc/rev、3.0cc/rev、6.0cc/rev

Details
General information
The center plate and gears, the front friction plate, the cover, the drive shaft and the idler shaft are made of tempered stainless steel. The body is in cast iron. The drive shaft sealing is done by Teflon packing. A compression sleeve and a hex-nut are used to achieve the desired tightness on the drive shaft. The Teflon packing seal is the only sealing available on this model.

For dosing abrasive products, this type of pump (except for outputs of 0.1 and 0.3cc/rev) can be coated with titanium (PT1 and T1). For dosing moderately abrasive products or to increase the life of the pump, it is possible to titanium coat only the plates. It is also possible to apply a coat of ADLC (Amorphous Diamond Like Carbon) on the different elements of the pump (PT2 and T2 ). ADLC low friction ratio makes it the perfect solution for pumps dosing water and solvent based paints as well as for the dosage of non lubricating products.


Options

(PT1) Front friction plate and rear cover titanium coated
(PT2) Front friction plate and rear cover ADLC coated
(T1) Center plate, gears, shafts, friction plate and cover (starting with 0.6cc/rev ouput) titanium coated
(T2) Center plate, gears, shafts, friction plate and cover ADLC coated.
(Z) Counter clockwise roatation
(AZ) Clock and couter clockwise rotation
(10) Drive shaft diameter ? 10mm with 9mm flat
(F) Reduced play ; usually for low viscosity products. Maximum rotation speed = 40min-1.
(J) Increased play ; usually for high viscosity products.
(R) Pre-set for flushing ; cover allowing the addition of a simple or double by pass bloc.
(OR) O’ring between the plates

Chongqing Paco Sci. & Tech. Development Co., Ltd.

Mobile:86-13594000884

Phone:86-23-68795340

E-Mail:yu@chinacqpaco.com

Address: No. 27-31, No. 67, Xisheng Road, Chenjiaqiao Street, Shapingba District, Chongqing, China